HKRUB Series (Tire Mold Patterning Rubber)

│ DESCRIPTION │
This product is used by the mixture of Part A and Part B as tire mold patterning rubber. This is a product that can model complex pattern of tire mold perfectly by optimizing the viscosity and minimize the mixed infusion of air bubbles.

│ FUNCTION │

• This is a product that can model complex pattern of tire mold perfectly by optimizing the viscosity.

│ FEATURE │

• Minimize the mixed infusion of air bubbles.

│ WAY OF USE │

1. In order to improve the physical properties of the product, Part A and Part B are uniformly stirred for about 3 minutes before using them.


2. Input Part A and Part B into a clean container with the proper ratio (Part A 100: Part B 14) and mix them uniformly over at least 2 minutes with the mixing machine, and at this time, pay heed to mixing the bottom of the container and the part of the side surface carefully.
   ※ Mixing ratio: adjusted to suit for product quality and working environment (using range: 12-16%)


3. Preparation before Use
   - Sometimes coating with mold releasing agent on the whole surface of master model in order to facilitate its .
   Drying by using an air gun after coating or drying in the natural state for over 30 minutes. (In coating, use a soft brush.)
   - Coating with the adhesive to improve the adhesion of the surface of rubber and model case. (In coating, use a soft brush.)

│ Precautions for Storage and Mixing │

• Storage Temperature of Part A & Part B: 23~30℃(the optimal temperature of the product: 23~25℃)
• Worker's Wearing of Safety Equipment: to wear the safety shoes, protective glasses, rubber gloves, and mask before working
• Agitation should be carried out in the well-ventilated area.
• Use as soon as possible.

│ Curing Conditions │

• Part A & Part B should be worked at the temperature of 23~30℃ which is the optimal temperature
• Temperature of Workshop: maintaining more than room temperature(more than 20℃)
  ※ Recommended temperature : 25~30℃
• Curing time: more than 14 hours
• The curing speed becomes faster at the temperature of more than 25℃, and becomes slower at low temperature.
.
• At the product temperature of below 20℃ and over 30℃ above, please avoid using it, if possible.
  ※ Please keep the using standard.

│ Precautions in Use │

• Read and understand the MSDS of HKRUB Series before using it.
  - In case of eye contact: wash up with a large amount of water or normal saline, for 10 to 20 minutes until the chemical is not left. Get medical attention immediately.
  - In case of skin contact: wash up with soft cleaner or a large amount of water, for 10 to 20 minutes until the chemical is not left. Get medical attention immediately.
  - In case of inhalation: let him/her inhale fresh air and, if necessary, give him/her the artificial respiration.


• Get medical attention immediately.
  - In case of ingestion: perform the gastric lavage within 15 minutes and give him/her medical attention immediately.
  - Notes to Physician: no specific antidote. Give him/her dependant medical care, based on symptoms.

│ SPECIFICATION │