Creep and creep to failure tester is suitable for the quantitative determination of sealing strength, heating sealing quality, burst pressure and leakage of three side seal flexible and aseptic packages.

The three test modes of the Creep and creep to failure tester are as follows:

A.      Burst Test:  It internally pressurizes the packages until the package fails. The test pressure is the maximum pressure detected before the package fails.

B.      Creep Test:  Pressurize the package internally to a specific pressure and maintains this pressure for a specific time. The test measure is pass/fail.

C.      Creep to Failure: The package is creep-tested and held until the package fails. The pressure setting is higher than that of the creep test to ensure the package fails in some time. The measure is the time until failure.

Creep and creep to failure testerFeatures

1.       Three test modes of burst, creep and creep to failure are available.

2.       PLC programmable logic controller realizes precise pressure and time control.

3.       7 inch TFT touching screen for convenient parameter setting and test operation.

4.       Multiple groups of test parameters can be save to avoid repetitive setting.

5.       Test result auto statistics and storage.

6.       Program customization available.

Technical Specifications

Pressure Range        0 ~ 600 KPa;  0 ~ 87.0 psi (Standard)

Sampel width   300mm

Gas Pressure          0.4 MPa~0.9 MPa

Standards

ISO 11607-1, ISO 11607-2, ASTM F1140, ASTM F2054, GB/T 10440, GB 18454, GB 19741, GB 17447, GB/T 17876, GB/T 10004, BB/T 0025, QB/T 1871, YBB 00252005, YBB 00162002