Solid state High Frequency welder

1. Switch rectifying cabinet

 The switchgear and the rectifier are integrated here into one switch rectifying cabinet, which enables both the switchgear function, and rectifying control function of the solid state H.F.welder.

Incoming MCCB(Model case circuit breaker),incoming current meter, incoming voltage meter(switchable type),and incoming voltage indicator.

 3-phase full-control thyristor rectifying bridge power regulation.

 Smooth reactor, soomthing capacitors and filter to increase the smooth coefficient.

2. Inverter output cabinet

 The inverter circuit consists of MOSFET single-phase inverter bridges connected in parallel, with the power of each bridge designed as120KW/60KW.Thus the power is accumulated in the style of building blocks. Each inverter board is designed into the drawer structure with slides on both sides, which facilities installation and repair.

The powers is combined through several transformers(called matching transformers) and by direct resonance between the tank circuit capacitors(low voltage)and the inductor, it is transferred to the welding unit via the bus lead and no welding transformers is needed here.

Sealed cabinet with air conditioner installed on the top of it.

3. Central operator console

 The central operator console allows remote operation and power regulation of the welder. It is equipped with HMI (human/machine interface),indicate DC voltage and DC current of the H.F welder, and armature voltage and field voltage of motors of the forming and sizing mill. Design of the central operator console is customized according to different types and quantities of motors. The power speed closed loop control/automatic power-speed control function is optional.

4. Mechanical adjustment device

2-D mechanical adjustment device: applicable for solid state induction welders only. The inverter output cabinet is installed on the adjustment device, so the position of inductor can by manually adjusted.

3-D mechanical adjustment device: applicable for both solid state induction welders and solid state contact type welder. The inverter output cabinet is installed on the adjustment device, so the position of the inductor can be adjusted manually or electrically.

5. Closed loop water cooling system

 The GPKL-2 cooling system adopts a closed cooling tower, in which the blowers and water spaying hoses on the top will cool the soft water already pumped into finned tube. The spraying water(normally purified tap water)is accumulated at the bottom of the cooling water. It is pumped into spraying hoses and sprays onto the surface of finned tubes—part of the spaying water will vaporize when it is falling, thus carries away some heat and partially lower the temperature of the soft water circulating inside. The vapor goes up due to the blower and intensifies the cooling effect when it passes the finned tubes again, and finally goes out of cooling tower.The other part will fall through the PVC heat exchange layer which is lacated under the tow blowers and above the finned tubes, thus gets cooled by the cold air passing by and finally joins the spaying water at the bottom.