We are able to produce all the spare parts for the INDECO series listed below:

MES Series:                                                           HB Series:

MES 121                  MES 2000                            HB 5

MES 180                  MES 2500                            HB 8

MES 300                  MES 3000                            HB 19

MES 350                  MES 3500                            HB 27

MES 521                  MES 4000                            HB 2000

MES 553                  MES 5000

MES 621                  MES 7000

MES 1200                MES 8500

MES 1500

MES 1750

MES 1800

Not only INDECO breaker but also RAMMER, KRUPP, MONTABERT, DNB,  FINE, KOMAC, NPK, MTB, SOOSAN, TOPA, TABE, MSB, TOKU, ATLAS COPCO, STANLEY, FURUKAWA, DAEMO, KWANGLIM, OKADA hydraulic breakers are in production scope of us.

Notice: The word INDECO and the use of model numbers are for illustrative and reference purposes only. ATILIM MUHENDISLIK INSAAT SANAYI IC VE DIS TICARET LIMITED SIRKETI is NOT affiliated in any manner with any company mentioned herein. Parts sold by ATILIM MUHENDISLIK INSAAT SANAYI IC VE DIS TICARET LIMITED SIRKETI  may be of original equipment or aftermarket manufacture.

Chisels are produced in our own plant with CNC lathes and milling machines. Since working condition of chisels are very hard and material is hardened, chisels are susceptible to fatique failure (early failure due to vibrated loads). One of the parameters which is efective on fatique strength is surface roughness. Surface finish is critical for chisel performance.

We produce chisel using modern cnc machines and cutting tools to get precise surface finishing.

We are able to produce a kind of spare parts such as front head, chuck housing, side rod, side rod nut, thrust ring, rubber ring, swivel joint, inner bush, upper bushing, front cover, lower bushing, pin tool, seal retainer, chisels, piston, cylinder, wedge, accumulator, lock washer, through bolt, top buffer, side buffer, repair kit, seal kit brackets, etc... of INDECO hydraulic hammer breaker.

HEAT TREATMENT

For chisels, heat treatment should be perfect also. Heat treatment in uncontrolled environment  will make the product too soft or too brittle.

When Low hardness (ductile):  Tip deformation, bending of shaft, early abrassion

When High hardness (brittle):  Prone to fructure failure

Heat treatments of our chisels has been made by our sup-suplier company for years.

All Overseas orders will be carefully packed before sending for shipping. Each product is descriptively labelled and wrapped. Finally, your purchasings are placed in safely wooden boxes.